Bailey Channel HD – HZ XR – XC Wag Upper Tailgate



Tailgate Bailey channel which fits into the upper opening of the upper tailgate.

Please note: To fit this bailey channel into the upper opening, first make sure that all of the original bailey channel has been removed and cleaned, relieve the bailey channel in the corners by using a sharp knife and carefully cut through the top of the channel into the sides (not more than half way down) approximately 10 mm spacing’s

Tip: Place the channel along the opening to know were the curves start before cutting.

Glue where needed with contact adhesive to make sure the channel stays put, don’t be in a hurry to install the channel.

If the ends on the original channeling are intact, these can be cut off and glued to the ends of the new channeling to seal the tailgate completely when the glass is up.

This product suits

Holden HD, HR, HK, HT, HG, HQ, HJ, HX and HZ

Ford XR, XT, XW, XY, XA & XB